Can a Bosch icp-cc488 dial 2 mobiles?

Can a Bosch icp-cc488 dial 2 mobiles?

so ive had a bosch ICP-CC488 installed for years no problems, installed myself and programmed (with the help of a mate). Set up to dial 2 mobiles when setoff. along comes NBN and the PTSN disconnection, alarm no longer calls the mobiles, lots of research and its obviously a issue and the easiest way was to buy a dialler.

Can You program the icp-cc488 control panel?

You can program the ICP-CC488 Control Panel You can alternatively press and hold [*] on the using any of these devices: touch-tone telephone for 3 sec to arm the system. After storing information in the programming Data Zone Indicators key, you can easily program other ICP-CC488 Value MAINS Control Panels with the same programming data.

How to turn off two beeps on icp-cc488?

Take the time to read performance. Enter command [9 6 0] and press [AWAY] to exit Quick Start from Installer’s Programming Mode. The following steps allow you to use the ICP-CC488 Two beeps sound and the STAY and AWAY Control Panel with factory default values. The default indicators are extinguished.

What is the code for the Bosch panic alarm?

Bosch Security Systems, Inc. | 12/08 | F01U089457-02… 66). A codepad Panic Alarm transmits Contact ID Event Code 120 if the system reports to a base Single button disarming from STAY station receiver. Mode 2 reports as User Code16. Bosch Security Systems, Inc. | 12/08 | F01U089457-02…

How to install the icp-cc488 control panel?

1.1 Introduction Thank you for choosing the ICP-CC488 Control Panel for your installation. You will find this system extremely flexible, reliable, and easy to use. This Quick Reference Guide is supplied with the system to provide users with enough basic information to wire, configure, and program the system.

How to disarm an ICP with master code 2580?

Enter the default Master Code (2580) and press [AWAY] to disarm the system and to reset any alarm that occurred when you powered up the system. The AWAY indicator is extinguished to signify that the system is disarmed. If any zone indicator is flashing, an alarm occurred in that zone.

Who is the owner of Bosch Security Systems?

Copyright Notice Unless otherwise indicated, this publication is the copyright of Bosch Security Systems, Inc. (“Bosch”). All rights are reserved. You may download a single copy of this publication.