The Daily Insight

Featured Article

How do I reset my Logitech Harmony 665?

How do I reset my Logitech Harmony 665? Press and hold the Menu button (located above the Channel Up button) and the Off button together for 20 seconds. T...

Read Full Article Browse updates

Knowledge Base

Latest insights and tutorials from the The Daily Insight team.

Can I connect my laptop to my smart TV with HDMI?

Can I connect my laptop to my smart TV with HDMI? To connect a laptop to TV with HDMI, just plug an HDMI cable into the HDMI port on each of the devices. ...

Why do I have broadband but no internet?

Why do I have broadband but no internet? If your computer is the only device that says it has a connection but no actual internet, it is likely that you h...

Are Crosley record players that bad?

Are Crosley record players that bad? Most collectors of vinyl records criticize the Crosley brand. It has a reputation for having poor quality and perform...

Do TVs get software updates?

Do TVs get software updates? If the TV isn’t connected to the internet: Occasionally, updates are offered through the antenna or a digital cable signal. S...

How do I connect my TV to auxiliary audio?

How do I connect my TV to auxiliary audio? If your TV doesn’t use RCA connectors for audio output, it may have a headphone out port (3.5mm port). You can ...

How do I connect my Denon AVR?

How do I connect my Denon AVR? Procedure: Press the “Setup” button on the remote control. Select “Network” from the menu. Then, select “Connection” follow...

How do I reset my Bose SoundLink 3?

How do I reset my Bose SoundLink 3? Reset the speaker. Press and hold Mute on the speaker for ten seconds until all status indicators briefly illuminate a...

What was the power of a pioneer sx-3800?

What was the power of a pioneer sx-3800? Pioneer SX-3800 Receivers. In Pioneer’s extensive receiver lineup for 1980, The SX-3800 was in the upper third in...

How do I reset my Pioneer VSX 70?

How do I reset my Pioneer VSX 70? Page 69 highlights Switch the receiver into standby. While holding down ENTER on the front panel, press u STANDBY/ON. Th...