How do I change the master code on my DSC alarm?

How do I change the master code on my DSC alarm?

How do I change the DSC 1616, 1832, and 1864 master code?

1. Enter *8-installer code.
2. Enter 007 to change the master code.
3. Enter a unique 4 digit code. The system should beep 3 times and exit back out.
4. Press # to exit programming mode.

How do I change master code on DSC Neo?

How do I change the installer code and/or master code on the DSC NEO?

1. Using *8 and the current installer code, enter programming mode.
2. Enter section 006.
3. Go to subsection 001 to change the installer code, if desired.
4. Enter the new 4 digit code.
5. Go to subsection 002 to change the master code.
6. Enter the new 4 digit code.

What is the default DSC installer code?

Default Master and Installation codes for DSC systems Depending on the type of system you have, the default installer code will be 5555, 5010, 1550, or 1500. To get into programming you’ll press * 8 then the installer code and then you’ll see a red lock appear letting you know you’re in programming.

How many access codes are in the DSC pc5010?

• 38 Access Codes: 32 User, 1 System Master, 2 Partition Master, 2 Duress and 1 maintenance • Wireless expansion available using the PC5132 Wireless Zone Expansion Module (up to 32 wireless zones, 900MHz, True Spread Spectrum Technology, Fully Supervised) • Will not lose programming or system status on complete AC and Battery failure

What is the default master code and installer code?

The DSC 1616, DSC 1832 and the DSC 1864 all come with the same default factory master codes and installer codes. If you just bought or defaulted your PowerSeries panel, the codes will be at these defaults. If you are taking a system over, there is a high probability that the codes will be changed.

What is the installer code in DSC programming?

The installer code is the code that is used to get into the DSC programming mode so you can set the system up and make changes to panel programming. Having the installer code is the most important part of setting up the system.

How many wireless keypads can a DSc pc5100 have?

The system can have a maximum of four wireless Handheld Keypads. The PC5100 will allow addressable multiplex loop devices to be added to the system. These devices use a 2-wire connection for power and to communicate with the control panel.