How do I get my Kenwood CD player out of Protect Mode?

How do I get my Kenwood CD player out of Protect Mode?

Turn off the receiver and let it cool for a few hours; then try again. If the protection mode warning doesn’t go away on its own, press the reset button. If that doesn’t work, disconnect the power lead from your receiver for 30 seconds and then reconnect it.

Why does my CD player says protect?

“Protect” is an indicator that there are either shorted speaker outputs inside the unit, a shorted speaker wire, or a blown speaker connected to the unit. If you’ve pressed the reset button, and it’s still in “Protect”, then disconnect all of the speaker wires connected to the head unit.

Is it possible to troubleshoot a Kenwood CD player?

Kenwood CD players are easy to troubleshoot. What might seem like a malfunction is often just a case of mis-operation, or settings not being specified correctly. In particular, take into account that CDs can get scratched or suffer heat damage in hot cars. It’s always a good idea to run through some troubleshooting steps before calling for service.

What does TOC error on Kenwood CD player mean?

“TOC Error” means either no disc has been loaded into the magazine, the disc is upside down, or the disc is badly scratched.

When did the Kenwood disc changer come out?

Note that any Kenwood disc changers/ CD players released in 1997 or earlier and disc changers made by other makers cannot be connected to this unit. Connecting unsupported disc changers/CD players to this unit may result in damage. Set the “O-N” Switch to the “N” position for the applicable Kenwood disc changers/ CD players.

What to do if you have a problem installing a Kenwood?

窶｢ If you experience problems during installation, consult your Kenwood dealer. 窶｢ When you purchase optional accessories, check with your Kenwood dealer to make sure that they work with your model and in your area. 窶｢ We recommend the use of (page 18) to prevent theft.