How do I program my Kenwood Excelon radio?

How do I program my Kenwood Excelon radio?

You can set up the tuner.

1. Select the Tuner source. Refer to .
2. Press and hold the [AUDIO] button. Enter the Function setting mode.
3. Use the [Control knob] to select “SETTINGS”.
4. Use the [Control knob] to select a Tuner setting item.
5. Use the [Control knob] to select a setting.

How do I connect my Bluetooth to my Kenwood DNX6160?

1. 72 DNX SERIES DNX6960/DNX6160/DNX6020EX/DNX6460BT/DNX5160.
2. Bluetooth Unit Connection. Selects the Bluetooth unit to connect.
3. Display the Bluetooth Setup screen.
4. Touch [ ]
5. > [ ]
6. > [Bluetooth SETUP]. (page 62)
7. Display the Connect Device List screen.
8. ⁄ [A2DP Connect Device] • Only for DNX5160 and DDX516 with optional.

How do I change the channel on my Kenwood radio?

To set a specific channel: Turn the radio off and hold down the menu button. While still holding down the menu button, turn the radio back on and then release the button. Using the arrow keys, select whichever channel number you prefer.

How do I get my Kenwood radio to work?

Kenwood Car Radio Instructions

1. Press the “Reset” button first if you’re using the Kenwood unit for the first time, or after changing the car’s battery.
2. Set the clock by pressing and holding the “Display” (DISP) button for one second.
3. Press “SRC” repeatedly until “Tuner” appears to hear the radio.

Where is the reset button on a Kenwood radio?

Find a pointed tool such as a small screwdriver, locate the small red triangle light-up button located on the top left of the stereo and press it down for 5 seconds. This will reset your Kenwood stereo.

How do you replace a Kenwood radio?

6.4 Changing the analog radio settings

1. Press the volume knob to enter Function mode. “FUNCTION” appears.
2. Turn the volume knob to select SETTINGS, then press the knob.
3. Turn the volume knob to select a desired setting item, then press the knob. See table below for selection.
4. Press and hold [6] to exit. Item.