How do I reset my DVR NVR?

To factory reset the device, hold the reset button down and unplug the NVR from power. Once power is removed from the unit, continue holding the factory reset switch for 4 – 5 seconds, continue holding the reset switch and plug the power supply back into the unit.

Why does my DVR keep rebooting and restarting?

DVR / NVR: System continuously restarting If the DVR / NVR is rebooting repeatedly, the issue may be caused by insufficient power or a hard disk drive (HDD)error. Check that the correct power adapter is in use and that the DVR / NVR is receiving sufficient power. To check the power connection on the DVR / NVR:

Why is my DVR not recording all channels?

The problem is when I try to set the system in settings it would not let me keep “all” channels for motion under “schedule” nor under “record setting”. After pressing “ok” on the different screens it would not save and upon reopening each screen both would stay return to channel 1 in the drop menu and record setting as “regular” instead of motion.

What to do if your DVR won’t save?

After pressing “ok” on the different screens it would not save and upon reopening each screen both would stay return to channel 1 in the drop menu and record setting as “regular” instead of motion. I can only turn all cameras off or keep them recording full time.

Why does my Swann DVR keep rebooting?

Sometimes you may see the loading screen with the Swann logo but after a 1-2 minutes the DVR reboots again and then starts over from the beginning. In this article we will show how to diagnose and fix the Swann boot failure issues.

How can I tell if my DVR hard drive has failed?

Indicators the Hard Drive on your DVR may have failed. If you try to access recorded video surveillance footage and you cannot find any video in the history or playback section of your DVR. When DVR’s boot-up there is a “test” phase that they run through to check for any errors prior to going into the programmed recording mode.

Why is there no video on my DVR?

If you try to access recorded video surveillance footage and you cannot find any video in the history or playback section of your DVR. When DVR’s boot-up there is a “test” phase that they run through to check for any errors prior to going into the programmed recording mode.

How can I stop recording shows on my DVR?

If you wish to stop recording a series, head into the “Scheduled” section of your DVR, find an upcoming episode of the series, and hit “Get More Info,” followed by “View Series Info”. From there, you can select “Cancel Recording.” How Many Shows Can a Spectrum DVR Record at Once?

How do I reset my DVR NVR?