How do I reset my Jandy control panel?

How do I reset my Jandy control panel?

How do I Reset a Jandy AquaLink System?

1. Press the “Menu” button.
2. Scroll to and highlight “System Setup” using the arrow keys. Press “Enter.”
3. Scroll to highlight “Clear Memory,” then press “Enter.” You have now reset your AquaLink system.

How do you reset an AquaPure salt system?

Press and hold the ‘Pool Temperature’ (‘D’) key for 15 seconds. The system will beep when the button is pushed, it will beep again after 10 seconds, and again after 15 seconds. Release the key after the third beep. Press ‘Salinity’ (‘C’) key within 5 seconds to enter temperature change screen.

How do I program my AquaLink rs6?

Basic Programming: To set a particular piece of equipment to turn on and off at a predetermined time, press the MENU button, press the forward arrow button to scroll to the PROGRAM menu, press ENTER, and then press the button for the equipment that you want to program.

What is SPA mode?

During the time in “spa mode” the pool is essentially stagnant as no water is being sucked, filtered, heated or returned to the pool at all. By allowing the spa to operate isolated like this your system can now begin heating the water from 80 degrees up to 104 degrees. Most pool and spa owners are not.

How do I test my pool relay?

How to Test an Electrical Relay

1. Step 1 – Test Electrical Item. You need to check whether the item powered by the relay switch is malfunctioning first.
2. Step 2 – Measure Power Supply. Check both power supplies to the relay to confirm the presence of 110v AC and 12v DC.
3. Step 4 – Check Ground.
4. Step 6 – Replace Relay.

How do you recalibrate Jandy salt?

Press the “Salinity”button and hold it until it beeps 3 times. The system will beep when you push it and then at 5 seconds and again at 10 seconds. Release the button after the 3rdbeep. Press and release the “Temperature “button within 5 seconds to enter the salinity calibration screen.

What are the different types of Jandy power centers?

Take control of your swimming pool with Jandy Pro Series control system power centers. Available in foundation, standard and sub‐panel with 12 breaker mount plate slots and knockout… Purelink Power Centers combine all the features of the AquaLink Power Centers and AquaPure water…

How many wires does Jandy Aqualink Rs board have?

The Aqualink RS board has one or two RS-485 connections. You can connect at least 2 sets of wires to each RS-484 connection. Depending on if your panel has 1 or 2 ports you can have 2 or 4 devices hooked up Jandy has the #6584 Multiplex PCB Kit for connecting more than 2 sets of wires.

How to enable spillover control on Jandy pool?

If a non-booster pump cleaner is installed, plug the JVA into the cleaner JVA socket. If you have a pool and spa you can enable the Spillover function with dip switch #3 on the main panel. When switch #3 is on then AUX3 becomes the spillover control.

How does an aux relay work on a Jandy pool?

AC on one line will turn the valve one way and AC on the other line will turn the valve the other way. You could use the Aux relay to control the 24 VAC so that it will turn the valve using the following circuit. But normal Aux relays won’t work as they do not have any Normally Closed contacts. You need a relay that has NC and NO contacts.