How do I reset my uverse receiver?
Emily Sparks
Published Apr 24, 2026
How do I reset my uverse receiver?
Many receiver problems can be fixed by restarting your receiver. To do this, press and hold the Power button for 10 seconds. This takes 5-8 minutes and will impact any DVR recordings in progress. If you have multiple receivers, reboot your wireless gateway by unplugging it from its power source.
How do I hook up my new TV to ATT Uverse?
On the back of the AT U-verse receiver, look for the connection HDMI. Connect the HDMI (shown above) to your television. Do not disconnect any Network or TO WALL cables. Plug your AT U-verse receiver into the wall to give it power.
What do I need to set up my U-verse wireless receiver?
Make sure you have the Wireless Receiver, power cord and U-verse TV remote control that came with the Wireless Receiver. You may have also received a Wireless Access Point, Ethernet cable and power cord. In order to complete the setup, you will need to locate your AT Wi-Fi Gateway. You will also need a cable to connect the receiver to your TV.
What kind of TV receiver does at & t you verse use?
Introduction Congratulations on receiving an ENERGY STAR®qualified Motorola VIP2200 Series High Definition U-verse TV Receiver.
Why does my U-verse TV have a red X on it?
For a more comprehensive list of error messages and other troubleshooting steps go to: A RED X on your TV screen caused by the U-verse receiver represents a boot failure, possible network issue, or hardware problem.
How do I set up my Uverse set top box?
1. Power down the router (unplug it) 2. Power down the uverse set to box (unplug it) 3. Disconnect all devices from the router including wireless devices. This includes phones and printers. Hint: disconnect your phone last: use Smart Home Manager to ensure all devices disconnect. 4. Power up the router 5. Power up the uverse set top box
Make sure you have the Wireless Receiver, power cord and U-verse TV remote control that came with the Wireless Receiver. You may have also received a Wireless Access Point, Ethernet cable and power cord. In order to complete the setup, you will need to locate your AT Wi-Fi Gateway. You will also need a cable to connect the receiver to your TV.
Introduction Congratulations on receiving an ENERGY STAR®qualified Motorola VIP2200 Series High Definition U-verse TV Receiver.
Where is the WPS button on my U-verse TV?
Press the Wi-Fi Protected Setup or WPS button on the front of the Wireless Access Point. This is the only button on the front of the Wireless Access Point. Follow the instructions on your TV. Locate and press the “OK” button on the front of the Wireless Receiver.
How to set up a wireless TV receiver?
Our first step is setting up your Wireless Receiver. You will need to make a video connection between the receiver and your TV by plugging one end of an HDMI component or other cable into the respective port on the back of the receiver. Connect the other end of the cable into the matching port on the back of your TV.
