How do you pair a second dog shock collar?

Press and hold Channel Switch / Match Button for 5 secs. The Receiver will vibrate and beep which indicates the matching is complete. You will see “1” (or subsequent number) in the Channel Display if matching is successful.

How do I pair my pet trainer collar and remote?

To sync the collar and remote, set the remote on channel 1 or 2, hold down the power butto… Call customer support for Petrainer, they will be glad to help.

How do I reset my dog care remote?

Press and hold the Upper Button on the Remote Transmitter until the Receiver Indicator Light flashes 5 times. You may need to hold both units 2-3 feet from each other before this occurs. Once the Receiver Indicator Light has flashed 5 times, the Collar Receiver has been reset and will begin flashing as normal.

Why is my Sportdog remote not working?

Support Topic Check to see if the Collar Receiver has been turned on. Make sure the collar and transmitter are programmed to work with each other. Check the batteries. Replace/recharge the batteries.

What do you do when your dog won’t wear a cone?

Hold the cone, or place it on the ground in front of you. Do not try and put it on your dog in any way. Reward with a treat any time your dog shows interest in the cone. Any time they sniff, touch it with their nose, or even look at it, praise and give a treat.

Why is my dog care shock collar not working?

Check that the battery on the receiver collar is fully charged and replace it as needed. Next, confirm that the transmitter and collar are properly synced. Then check that you haven’t set the correction level so low that it isn’t responding. Lastly, check the fit of the collar on your dog.

How do I reset my Sportsdog remote transmitter?

How to Reset the SportDOG Collar Receiver to the Remote…

Turn your Collar Receiver OFF.
Holding the ON/OFF button down, the Receiver Indicator Light will come on and turn off after approximately 5 seconds.
After the Receiver Indicator Light has been turned OFF, let go of the button.

How to pair the receiver with the remote?

(DOG CARE TRAINING COLLAR) – YouTube How to pair the receiver with remote? (DOG CARE TRAINING COLLAR) If playback doesn’t begin shortly, try restarting your device. Videos you watch may be added to the TV’s watch history and influence TV recommendations. To avoid this, cancel and sign in to YouTube on your computer.

Can a receiver collar be used as a dog collar?

The included collar is a basic accessory and is not necessarily suitable for all types of dog breeds. Any collar not wider than 24mm and not thicker than 5mm, made of soft material, can be a replacement for the current collar. The Receiver collar is not a regular collar and not recommended to put on a leash to walk your dog.

Can a Static Shock work on a dog?

Static is too weak or even completely no static; Static Mode has no effect on my dog. Make sure the receiver has enough power (when it is low-battery, shock doesn’t work); Only both electrodes are simultaneously touched by dog’s skin shock will work; Try to increase the static level to more than 45.

Can you use a bigleash remote trainer with two dogs?

Your transmitter is pre-set for use with one dog but can easily be programmed for use with two dogs. To use the BigLeash Remote Trainer with two dogs, you must have a receiver collar for the second dog (Collar 2). The collar for the second dog can be purchased from your local Dealer or from the online store.

How to use Dogwatch bigleash remote training collar 2?

Step 1: Before adding Collar 2 to the transmitter, charge it for at least 3 hours. Step 2: Make sure both the transmitter and the receiver are turned ‘off’. S-15 Remote Trainer: hold down the ‘A’ button for 10 seconds until the screen on the transmitter turns ‘on’. Step 4: Set the Training Level to ‘2’.

How do you pair a second dog shock collar?