How to disable phone options on a DSc alarm panel?

How to disable phone options on a DSc alarm panel?

The remaining DSC programming steps are to get rid of the systems faults indications and disable communications. *8 5555 015 7 ## removes the phone line monitoring; *8 5555 380 1 ## (380 1 ## if your already in the programming mode from before) to disable DSC communication i.e. phone dialing. Piece of cake after 8 hours of reading the two manuals.

How to turn off trouble light on DCs power 832?

If you will not be using the communicator functions, you have to turn them off by entering programming, turning off option 7 in section 015, and option 1 in section 380. Thanks for that. Just completed those steps but trouble light is still on.

Where can I find the DSC installation manual?

DSC offers a User Manual, but most of the other documents require you to be an installer For the control panel, find the Installer’s Manual, User Manual, Reference Manual, and Programming Worksheet. For the keypad, find the Installation Manual.

How long does it take to reset a DSc alarm?

Hold it down for at least 2 seconds to disengage the alarm. You will notice the lights on the alarm change from red to green to signal that the alarm has been reset. This also helps to reset the low battery light once the power has been restored.

How to turn off telephone line monitoring on DSC 1616, 1832 and 1864?

I’m not using a telephone line, how do I turn off telephone line monitoring on the DSC 1616, 1832, and 1864? Enter programming with *8 – installer code. Go to section 015. Turn off toggle option 7 by pressing 7. Press # twice to exit programming. Verify that the trouble condition for the phone line should is gone.

How to do time / date programming for DSC control panel?

Time/Date Programming for DSC Control Panel Time/Date Programming for DSC Control Panel Control Panel Required Keypad Entry PC500No time/date programming required PC550No time/date programming required PC580 Step 1 – Enter time/date programming by pressing [*][6] + [Master Code] + [1] Step 2 – Enter [HH:MM] [MM/DD/YY] Step 3 – Press [#] to exit

If you will not be using the communicator functions, you have to turn them off by entering programming, turning off option 7 in section 015, and option 1 in section 380. Thanks for that. Just completed those steps but trouble light is still on.

What to do if your DSC alarm is not working?

Investigate if the phone lines are working. If your alarm is connected to the phone lines, temporary phone outages can cause the alarm to ring. Call your phone provider from your mobile phone to find out if there have been any phone line problems in your area.