Is the Yamaha rx-v567 receiver a subwoofer?

Is the Yamaha rx-v567 receiver a subwoofer?

I have a Yamaha RX-V567 receiver and just picked up a used PA-150 subwoofer to hold me off until I put together my 18″ DIY build. I know the sub works because I had the guy demo it before I bought it.

How to connect a subwoofer to a Yamaha receiver?

You were correct on setting crossover, fwiw. Not familiar with your sub, but one unbalanced RCA, or one balanced cable is all that is needed…”sub out” from the receiver to “input” on the sub. Not familiar with your sub, but one unbalanced RCA, or one balanced cable is all that is needed…”sub out” from the receiver to “input” on the sub.

What to do when there is no subwoofer sound?

I don’t have the Ypao mic but have been told to manually go into the setup menu>dsp parameter>7 channel stereo and hit the setup button again to save setting. I have set the crossover frequency to 80hz, Subwoofer phase to normal, Extra bass off, eq type>GEQ, adaptive drc> off. WHAT AM I DOING WRONG?! This is driving me crazy!

How to test a Yamaha subwoofer setup mic?

Best served to acquire the Yamaha setup mic. If not getting any test tone from the sub at all, pull the cable from the sub pre-outs on the AVR and rub your finger over it. Hear static from the sub? If not, either the cable or the sub has a problem. Click to expand… I have a buddy who is going to let me use a mic tomorrow hopefully.

I have a Yamaha RX-V567 receiver and just picked up a used PA-150 subwoofer to hold me off until I put together my 18″ DIY build. I know the sub works because I had the guy demo it before I bought it.

You were correct on setting crossover, fwiw. Not familiar with your sub, but one unbalanced RCA, or one balanced cable is all that is needed…”sub out” from the receiver to “input” on the sub. Not familiar with your sub, but one unbalanced RCA, or one balanced cable is all that is needed…”sub out” from the receiver to “input” on the sub.

How to troubleshoot an arc Yamaha AV receiver?

ARC Setup / Troubleshooting for AV receivers. Verify Input Selection and volume: Receiver would be set to AUDIO 1 Input (initial setting). *The initial setting may differ depending on the product. For details, refer to the Owner’s manual.

I don’t have the Ypao mic but have been told to manually go into the setup menu>dsp parameter>7 channel stereo and hit the setup button again to save setting. I have set the crossover frequency to 80hz, Subwoofer phase to normal, Extra bass off, eq type>GEQ, adaptive drc> off. WHAT AM I DOING WRONG?! This is driving me crazy!