What are the zones on the accord XPC?

It contains ten zone links, a cable clamp (with two self tapping screws), two M4×20 mm lid screws, battery connector leads and 16 1K resistors. ZONE ZONE ZONE Figure 2.2 Accord xpC pcb SW1 — Accord Tamper Switch SW1 on the Accord control panel PCB is the control panel tamper.

Is there a master code for accord XPC?

I have an unmonitored Accord XPC Panel that I wish to default the Engineer & Master User Codes (not the zone programming etc.) back to factory settings. I have the Master Code but not the Engineer Code; the system used to be on contract but that was cancelled several years ago.

Is there an unmonitored accord XPC alarm panel?

Discussion in ‘ Electricians’ Talk ‘ started by polybear, Jun 19, 2007 . I have an unmonitored Accord XPC Panel that I wish to default the Engineer & Master User Codes (not the zone programming etc.) back to factory settings.

How do I Turn Off the tamper alarm on an accord XPC?

Put the system into Engineer Mode (also called Programming Mode in the manual) using the Enginner Code. Then you can remove the cover of the Control Panel (not the keypad panel) without the tamper alarm goung off. This will give you access to the backup battery, which is a sealed lead acid battery.

How much does it cost to replace an accord alarm?

The battery type number is marked on the side of the battery, and replacements are easily available from Maplin. It’s worth paying extra for Yuasa batteries. Fit the battery, put the cover back on then take the alarm out of engineer mode. The battery will cost you around thirty quid.

What are the zones on the accord XPC?