What causes blue indicator light on 1131 Cisco community?

What causes blue indicator light on 1131 Cisco community?

Maximum retries or buffer full occurred on the radio. Software failure; try disconnecting and reconnecting unit power. General warning, insufficient inline power (see the “Low Power Condition for Autonomous Access Points” section). DRAM memory test ok.

What does a blue access point light mean?

LIGHT GREEN = Access Point is operational, but no wireless clients are attached. BLUE = Access point is opertional and atleast 1 wireless is associated to the AP. ORANGE = Power issue at the access point. RED = Firmware issue. “Satisfaction does not come from knowing the solution, it comes from knowing why.”.

Why are the lights blinking on my U-verse TV?

If you are seeing no video and the red, blue, and green lights on your U-verse Receiver are blinking, a critical error has occurred with the U-verse Receiver. Restart your receiver by holding down the POWER button for 10 seconds then pressing it again to restart.

How old is the receiver on my TV?

Specifically, there is nothing showing up on the receiver’s display, and the TV is not registering that the receiver is connected (which it definitely is). The receiver is about 1.5-2 years old and was one my grandma bought and used for a few months before getting a TV with it built in.

What does the green light on the dish remote mean?

The green light signifies that it’s turned on and that it’s functioning properly. If, in any case, it’s blinking, you need to press + hold the power button. This would let the receiver boot up. After doing that, the next thing you want to do is to press the SAT button on your DISH remote.

What does the green light on my PVR mean?

Flashing green: Your PVR is connecting to the Fibe TV service. No light: Your PVR is not connected to your home network and nor to your Fibe TV service. If your receiver was just powered on, please wait up to 10 minutes for the light to turn solid green.

What is the green light on my 4K TV?

This light is only active while the 4K Whole Home PVR is restarting. Solid green: Your PVR is connected to your home network and Fibe TV service. Flashing green: Your PVR is connecting to the Fibe TV service. No light: Your PVR is not connected to your home network and nor to your Fibe TV service.

If you are seeing no video and the red, blue, and green lights on your U-verse Receiver are blinking, a critical error has occurred with the U-verse Receiver. Restart your receiver by holding down the POWER button for 10 seconds then pressing it again to restart.