What is the factory access code for scantronic 9651?

The control unit loads the factory default access codes: User 1: 1234, Engineer: 7890. Close the control unit and apply mains power. Carry out an engineer reset 1.

How to install an intruder alarm system ( IAS )?

Introduction: this describes the parts of an Intruder Alarm System (IAS) based on the 9651 control unit. 2. Technical Description: this defines the operating parameters of the different parts of the system. 3. Installation: this explains the tasks involved in installing an IAS using the 9651 control unit.

What kind of alarm does a 9943 alarm have?

The 9943 has a built-in wide-area proximity reader and connections for an external panic alarm switch. Both have a two-line 16-character Liquid Crystal Display (LCD) that can display alarm information, programming settings and other information.

When did I remove the 9941 keypad from my alarm system?

Discussion in ‘ Electricians’ Talk ‘ started by Graeme Thompson, Jun 2, 2020 . During a decorating binge I removed one of the 9941 keypads from our alarm system (inherited when we bought the house). I’ve reconnected it exactly as it was but now it won’t accept any commands.

What should I do if my scantronic 9651 is misbehaving?

This involves powering off, opening lid, disconnect battery, short NVM & kick-start pins, reconnect battery, close panel, power-up. I’m a bit scared of this procedure… once both mains and battery power is lost won’t the external Elmdene sounder sound?

What is the factory access code for scantronic 9651?