What is the trouble code on DSC pc1565?

What is the trouble code on DSC pc1565?

My DSC PC1565 security alarm is having trouble light shown on the panel. I have check the trouble code and it shows zone 1 – service required. Would anyone be able to help on what the problem is and how to fix it?

What are the trouble codes for DSC alarms?

Understanding DSC Alarm Trouble Codes. 1 Service Required (press [1] for more information) 1.1 Low Battery (main battery in panel) 1.2 Bell Circuit. 1.3 System Trouble. 1.4 System Tamper. 1.5 Module Supervision. 1.6 RF Jam Detected. 1.7 PC5204 Low Battery. 1.8 PC5204 AC Failure.

Why is the power panel on my DSC not working?

The following applies to all PowerSeries panels, which include PC1616, PC1832, PC5010, PC5015 and others. AC power is not present at the panel (the system is operating on stand-by battery power. The panel does not detect an active telephone line. The system attempted to communicate with the monitoring station but failed.

What does it mean when your alarm light stays on?

To determine what trouble you have press [1] again to view the specific trouble. If light 1 stays on, it indicates you have a low battery condition, and need to replace your system battery. If another number shows on your keypad, please contact SafeTech Technical Support. Loading…

My DSC PC1565 security alarm is having trouble light shown on the panel. I have check the trouble code and it shows zone 1 – service required. Would anyone be able to help on what the problem is and how to fix it?

How does an alarm work on a pc1555rkz?

If an alarm occurred while the system was armed, the Memory light (or System light on a PC1555RKZ keypad) and the zone light corresponding to the zone which caused the alarm will flash for 30 seconds. After the 30 second period, the Memory (or System) light and zone light will stop flashing and the panel will return to the Ready state.

Where can I find a DSc alarm manual?

You can find links to free DSC manuals on my alarm system manual sources page. Go to any keypad and press “*”, then “2”. The keypad will switch from its “idle” display to its “trouble code” display. The lit LED’s or text will now correspond to the trouble code table.

How can I Stop my DSC home alarm from beeping?

You can easily toggle this on or off by pressing and holding the “Chime” button on any keypad that has function keys. For keypads without a chime button, just press “*4”. On this page, I’ll show you how to silence trouble beeping, and how to use a few easy keypad commands to find the source of the trouble.