What to do when your pioneer AMP says Zone 2?

While holding down the “Band” button, press and hold the “Power/Standby”button for about 2 seconds. 3. When you see “Reset” appear on the display, press “Auto Surround/Stream Direct”. 4. “OK” will show on the display.

Can you get Zone 2 speakers to work?

I cannot get sound from Zone 2 (my patio speakers). I have tested the speakers and they work. (I ran the receiver test of the speakers and the outside speakers have sound.) The receiver is working great inside my house.

What does OK mean on a pioneer AMP?

“Ok” will appear to confirm that it has been reset to factory defaults. Keep in mind that this will take the unit back to factory default and all custom settings will have to be done again. The “ue33” error code means that the machine was trying to update firmware via the ethernet connection and it failed.

Where are the Zone 2 speakers on the vsx-1019ah?

I have the patio speakers connected to the Zone 2 speaker connections on the receiver, which are the Back Surround Speakers. I have selected Zone 2 in the Receiver on screen Menu for the Back Surround as well. So, those bases are covered.

Can a 7.1 AV amp be used as a Zone 2?

Most people do not have the space for a proper 7.1 system with surround back speakers so the AV amp manufacturers give you some extra options to use the surround back channels. You can either use them for zone 2; this is where you have a set of speakers in another room.

How many speakers does a pioneer vsx-817 have?

Clearing all the remote control settings: While pressing the RECEIVER button, press and hold the 0 button for three seconds. This does not work either. I am using 4 speakers (2 in front & 2 in surround back). What mode is best used: 2 Zone or Bi-amp. Apparently Bi-amp gives equal output in all 4 spkrs. (My spkrs are 6 ohm (Front) & 8 ohm (Back))

What to do when your pioneer AMP says Zone 2?