When did the Optoma hd25 projector come out?

When did the Optoma hd25 projector come out?

From Optoma — Discontinued September 2013 The Optoma HD25 delivers stunning high-definition 1080p video with unsurpassed color accuracy and incredibly sharp detail. It’s the ideal projector for today’s big-screen home theater experience.

Can a DLP projector be repaired by Optoma?

Please call Optoma before you send the unit for repair. ‡ See projector enclosure for safety related markings. ‡ The unit should only be repaired by appropriate service personnel. ‡ Only use attachments/accessories specified by the manufacturer. ‡ Do not look into straight into the projector lens during operation.

Why do I have problems with my projector?

There are a few reasons why this may be occuring, the first thing to check first is your projector cables, the best thing to do first is to change these to see if this fixes the problem. If not, the problem may lie with your colour wheel / main board. This is a problem caused by the projectors main board.

What should I do if my projector ballast goes?

If this is all OK, then it most likely you have a problem with your lamp ballast unit or the lamp itself. The lamp ballast unit is what provides power to the lamp. If the lamp ballast unit goes, then most likely the lamp will usually go as well. Price varies on these units so your projector would have to be taken in for an assessment.

When to use lens cap on Optoma projector?

Allow 90 seconds for the projector to cool down. Warning- Do not use lens cap when projector is in opera- tion. Warning- When the lamp is approaching to the end of its life time, the message “Lamp life exceeded.” will show on the screen.

When to change the lamp on an Optoma?

Please be sure to change the lamp when it shows warning messages. Warning- Reset the “Lamp Reset” function from the on- screen display “Options|Lamp Settings” menu after replacing the lamp module (refer to page 49). Warning- When switching the projector off, please ensure the cooling cycle has been completed before disconnecting power.

Please call Optoma before you send the unit for repair. ‡ See projector enclosure for safety related markings. ‡ The unit should only be repaired by appropriate service personnel. ‡ Only use attachments/accessories specified by the manufacturer. ‡ Do not look into straight into the projector lens during operation.

When to change the lamp on a DLP projector?

Please be sure to change the lamp when it shows warning messages. ‡ Reset the “Lamp Reset” function from the on-screen display “Lamp Settings” menu after replacing the lamp module. ‡ When switching the projector off, please ensure the cooling cycle has been completed before disconnecting power. Allow 90 seconds for the projector to cool down.