Why is my HITRON modem not connecting to the Internet?

Why is my HITRON modem not connecting to the Internet?

Hitron CODA-4582: The modem will not be able to access the Internet without completing Easy Connect for the first time upon bootup or factory default resets. If you have a device wired directly to the modem you can complete Easy Connect without connecting to WiFi first.

How to change access settings on HITRON CGN3?

Go to the security section. Then down to manage device, and add managed device. You will need to find out the MAC address of the device. Enter it here, and then click on the manage all day and change the option. It should give you days of the week and what time to allow usage. 03-23-2014 08:42 AM – edited ‎03-23-2014 08:44 AM

How do you factory reset a HITRON gateway modem?

You can factory reset any of the modems by holding a toothpick or pin or something firmly into the pinhole for about 45 seconds. The modem will then reboot; once it’s back up you should be able to log in with the default info. That goes for any of the Rogers gateway combo modems, not just the Hitron ones.

What are the settings for a HITRON router?

More details on Hitron Router Settings: Administrative Password. After re-entering the password and selecting Confirm Setup you will have an opportunity to double check your settings before selecting Complete my Setup.

What happens if I Lose my HITRON router settings?

Loss of login access will require restoring to factory default and any currently customized settings will be lost. Shaw does not have access to these settings and will be unable to assist in restoring lost configurations.

How do I log in to my HITRON router?

Open an Internet browser (e.g. Google Chrome, Mozilla Firefox, Safari, Internet Explorer, etc.) and locate the address bar: In the address bar, type in the following: 192.168.0.1 and press the enter key on your keyboard. You will be presented with a Hitron login page. Login with your credentials: Hitron CGNM-2250.

How to fix HITRON coda-4582 not allowing Internet access?

The same should probably apply to the 4782. Connect a second router to the modem, power it up, wait for it to boot up, and then reboot the modem. After that modem reboot is complete, both routers should be up and running with their own WAN IP addresses. If that doesn’t work, disconnect the first router, connect the second router and power it up.

Go to the security section. Then down to manage device, and add managed device. You will need to find out the MAC address of the device. Enter it here, and then click on the manage all day and change the option. It should give you days of the week and what time to allow usage. 03-23-2014 08:42 AM – edited ‎03-23-2014 08:44 AM